[ad_1] ABSTRACTThe technique used worldwide while drilling is known as overbalanced drilling. Which is defined as the drilling process where the hydrostatic pressure used exceeds the formation pressure. This is done with the main purpose…
Read More[ad_1] ABSTRACT The scope of this work was to make detailed analysis of phase distribution in a horizontal pipe. This detailed analysis has been successfully carried out. Data obtained from wire mesh sensor (WMS) were…
Read More[ad_1] ABSTRACT Proper management of thin oil rim reservoirs is required to maximize recovery and minimizes coning tendencies. The objective of this study is to determine the effect of reservoir and fluid properties on coning…
Read More[ad_1] Petroleum Engineering Research project Topic Chapter 1-5 titled, Experimental Investigation Of Sp Flooding In Central Onshore Of The Niger Delta – A Case Study Of Reservoir-X. TABLE OF CONTENT TITLE PAGE CERTIFICATION DEDICATION…
Read More[ad_1] CHAPTER ONE INTRODUCTION Many reservoirs are comprised of relatively young sediments, which are so poorly consolidated that sand will be produced along with the reservoir fluids unless the production rate is reduced significantly. Sand…
Read More[ad_1] ABSTRACT A major drawback of directional and horizontal well drilling is the numerous complex computations required to be done while planning a well. These computations are very stressful and time consuming especially when done…
Read More[ad_1] ABSTRACT Oil deposits are often found in association with a communicating gas or water zone. The production of the oil often leads to the coning of water or gas. This dynamic interaction can be…
Read More[ad_1] CHAPTER ONE 1.0 INTRODUCTION The Nigerian petroleum industry which has majority of its establishment within the Niger Delta Region has been confronted by two sapping challenges over the years. The challenges relates to the…
Read More[ad_1] Introduction Hydrocarbons(oil and gas) are found in the pore spaces of sedimentary geologic formations (reservoir rocks). Once an oil or gas reservoir is discovered and assessed, production engineers begin the task of maximizing the…
Read More[ad_1] ABSTRACT Every simulation study is a unique process, starting from the geological model and reservoir description to the final analysis of recovery factor optimizations. In petroleum engineering area, numerical reservoir simulators are often employed…
Read More
Recent Comments